Allied-telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT Uživatelský manuál stáhnout pdf (Strana 93)

Allied Telesyn AT-VIEW PLUS

DEVICE MANAGEMENT

ARP Table

Displays the mapping of IP addresses to MAC addresses (the ARP cache) on the router.

Note - The current firmware version does not allow the user to configure the Physical

Address parameter. Attempting to configure this parameter will result in the error message:

"The error occurred with 'Set' operation. Error: gen Error."

Address Table

Displays the list of IP interfaces and their IP addresses on the router.

Route Table

Displays the IP routing table on the router.

Note - The current firmware version does not allow the user to configure the Destination Port

Number parameter. Attempting to configure this parameter will result in the error messages:

"The error occurred with 'Set' operation. Error: gen Error." or "The error occurred with 'Set'

operation. Error: bad value."

Note - The current firmware version does not allow the following parameters to be

configured:

• Destination Metric 1

• Destination Metric 2

• Destination Metric 3

• Destination Metric 4

• Next Hop Address

• Routing Type

• Route Updated Seconds

• Routing Mask

• Destination Metric 5

Attempting to configure these parameters will result in the error message: "The error

occurred with 'Set' operation. Error: gen Error."

IP Statistics

Displays statistics about IP routing, including the number of IP datagrams received.

Note - The current firmware version does not allow the Forwarding Status and the Default

TTL parameters to be configured. Attempting to configure these will result in the error

message: "The error occurred with 'Set' operation. Error: gen Error."

ICMP Statistics

Displays ICMP statistics.

PN 613-50665 Rev A Page 93 of 257

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 256 257

Žádné komentáře

Allied-telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT Uživatelský manuál Strana 93