Allied-telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT Uživatelský manuál stáhnout pdf (Strana 56)

Allied Telesyn AT-VIEW PLUS

DEVICE MANAGEMENT

Attempting to set this to any other value will result in the error message: "The error occurred

with 'Set' operation. Error: bad value".

Note - The Module ID and Port Number parameters return 'noSuchName'.

Spanning Tree Info

Displays the port's spanning tree parameters.

Enable

Enables the port.

Disable

Disables the port.

Port Mirroring

Displays port mirroring parameters and allows configuration of port mirroring state, source,

and destination.

IGMP Snooping

Displays the current state of IGMP Snooping and allows reconfiguration.

Note - Valid MIB Set values for the IGMP Report Delay parameter should range from 5 to

30. However, the current firmware version does not allow it to be set to a value greater than

10. Attempting to do so will result in the error message: "The error occurred with 'Set'

operation. Error: bad value."

Stacking Menu

From the Stacking menu, you can view basic switch information as well as stacking information.

Stacking Info

Displays information such as Hardware Version, Firmware Version, Expansion Slot, and

Role In System for all switches in the stack.

AT-8324SX

PN 613-50665 Rev A Page 56 of 257

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 256 257

Žádné komentáře

Allied-telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT Uživatelský manuál Strana 56