Allied-telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT Uživatelský manuál stáhnout pdf (Strana 25)

Allied Telesyn AT-VIEW PLUS

DEVICE MANAGEMENT

Event Table

Displays the RMON Event table.

Event Log

Displays the RMON Event log.

Port Menu

From the Port menu, you can view and edit MIB information about the port.

Utilization

Displays the port's utilization information.

Interface Info

Displays port statistics such as the number of frames received and transmitted on the port,

bytes received and transmitted on the port, and port status.

Note - Valid MIB Set values for the Administration Status parameter are 'up' and 'down'.

Attempting to set this parameter to any other value will result in the error message: "The

error occurred with 'Set' operation. Error: bad value."

Error Statistics

Displays error statistics.

Detail Info

Displays detailed port information such as duplex mode.

Note - Setting the Port Reset parameter to 'reset' will not reset the port's attributes.

Note - Valid MIB Set values for the Port Flow Control parameter are 'disable', 'transmit-

only', 'receive-only', and 'transmit-and-receive'. However, the current firmware version does

not allow this parameter to be set to 'transmit-only' and 'receive-only' for the following ports:

Expansion module ports •

•

GBIC ports on the AT-8024GB

Fiber optic ports on the AT-8026FC

10/100/1000Base-T ports on the AT-8026T

Note - For AT-8024GB devices, the current firmware version does not allow the Port Speed

and Mode parameter of the GBIC ports to be set to '1Gbps half-duplex'.

Note - Valid MIB Set values for the Port State parameter are 'enabled' and 'disabled'.

Attempting to set this parameter to any other value will result in the error message: "The

error occurred with 'Set' operation. Error: bad value."

PN 613-50665 Rev A Page 25 of 257

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 256 257

Žádné komentáře

Allied-telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT Uživatelský manuál Strana 25