Allied-telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT Uživatelský manuál stáhnout pdf (Strana 89)

Allied Telesyn AT-VIEW PLUS

DEVICE MANAGEMENT

Segment Status

Displays RMON configuration information of each segment.

Port Menu

From the Port menu, you can view and edit MIB information about hub's ports.

Statistics

Displays port statistics such as number of frames received/transmitted on the port, bytes

received/transmitted on the port and port status.

Status

Displays whether the port is enabled or disabled, whether it is partitioned and other status

information.

Detail Status

Displays information such as port name, LED status and polarity.

Note - A link between a port on the hub and a port on another device can only be established

if the port on the other device is configured to auto-negotiate.

Security Info

Displays source MAC addresses of frames received on the port.

Note - Valid MIB Set values for the Learn Action parameter are 'inactive' and 'active'.

Attempting to set this parameter to any other value will result in the error message "The error

occurred with 'Set' operation. Error: bad value.".

Note - The current firmware version does not allow the user to configure the MAC Address

parameter. Attempting to configure it will result in the error message "The error occurred

with 'Set' operation. Error: bad value.".

Enable

Enables the port.

Disable

Disables the port.

AT-FH800u

PN 613-50665 Rev A Page 89 of 257

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 256 257

Žádné komentáře

Allied-telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT Uživatelský manuál Strana 89