Allied-telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT Uživatelský manuál stáhnout pdf (Strana 70)

Allied Telesyn AT-VIEW PLUS

DEVICE MANAGEMENT

• Utilization

• Interface Info -> Standard

• Error Statistics -> Standard

• Spanning Tree Info

Utilization

Displays the port's utilization information.

Interface Info

Displays port statistics such as the number of frames received and transmitted on the port,

bytes received and transmitted on the port, and port status.

Note - Valid MIB Set values for the Administration Status parameter are 'up' and 'down'.

Attempting to set this parameter to any other value will result in the error message: "The

error occurred with 'Set' operation. Error: bad value.".

Error Statistics

Displays error statistics such as alignment error frames and carrier sense errors.

Detail Info

Displays detailed port information such as duplex mode.

Note - The current firmware version does not allow the Port Name parameter to be set to

NULL. Attempting to set this parameter to NULL will result in the error message: "The error

occurred with 'Set' operation. Error: bad value.".

Spanning Tree Info

Displays the port's spanning tree parameters.

Note - The current firmware version does not allow the Port parameter to be configured.

Attempting to configure this parameter will result in the error message: "The error occurred

with 'Set' operation. Error: readOnly".

Port Security

Displays the port security attributes for each physical port present in the switch.

Enable

Enables the port.

Disable

Disables the port.

Port Mirroring

Displays port mirroring parameters and allows configuration of port mirroring state and

port's source list.

PN 613-50665 Rev A Page 70 of 257

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 256 257

Žádné komentáře

Allied-telesis AT-VIEW PLUS 3.0 DEVICE MANAGEMENT Uživatelský manuál Strana 70