Allied-telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT Uživatelský manuál Strana 393

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 411
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 392
AT-MCF2012LC
10/100Base-TX to 100BaseFX (LC, 2km, MM)
LED State Description
DUPLEX
Green
Orange
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.
LT Green Link Test is enabled
ML Green Missing Link is enabled
SML Green Smart Missing Link is enabled
Context Menu
Note - Valid MIB Set values for the Port Operation Mode parameter are "smart
missing link", "missing link" and "link test". However, the current firmware version
allows the Port Operation Mode parameter to be set to "oam bypass" or "oam
visible".
Note - The current firmware version does not allow the Port Ingress Rate Limit and
Port Egress Rate Limit parameters to be configured. Attempting to set these
parameters to valid values will result in the error message: " The error occurred
with 'Set' operation. Error: bad value.".
Note - The current firmware version returns inconsistent values on the Port
Operation Mode parameter.
AT-MCF2012LC/1
10/100Base-TX to 100BaseFX (LC, 20km, SM)
LED State Description
DUPLEX
Green
Orange
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.
AlliedView™-EMS 4.0.1 Device Management Guide Page 393 of 411
Zobrazit stránku 392
1 2 ... 388 389 390 391 392 393 394 395 396 397 398 ... 410 411

Komentáře k této Příručce

Žádné komentáře