Allied-telesis AlliedView-EMS 4.0.1 DEVICE MANAGEMENT Uživatelský manuál Strana 363

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 411
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 362
Note - Configuring Prefix Length parameter will result in the error message
"The error occurred with 'Set' operation. Error: time out occurred."
However, the new value is still set successfully.
Route Number
Displays the IP routing number on the switch.
Route Table
Displays the IP routing table on the switch.
Note - The current firmware version returns the value 'NULL' for the Routing
Protocol MIB parameter.
Note - The following parameters are implemented as 'read-only':
Destination Port Number
Routing Type
Routing Protocol MIB
Next Hop AS Number
Destination Metric 1
Destination Metric 2
Destination Metric 3
Destination Metric 4
Destination Metric 5
Row Status
IP Statistics
Displays statistics about IP, such as the number of IP datagrams received.
Note - Valid MIB Set values for the Default TTL parameter should range from 1-255.
However, the current firmware version does not allow this parameter to be set to
'1' as its value. Attempting to set this parameter to '1' will result in the error
message "The error occurred with 'Set' operation: time out occurred." Connection
with the device will be lost and the only way to re-establish connection will be to
perform a manual reset.
UDP
Listener Info
Displays UDP listener information.
UDP Statistics
Displays UDP statistics.
TCP
Connection Info
Displays TCP connection-specific information.
Note - The Connection Status parameter is implemented as 'read-only'.
AlliedView™-EMS 4.0.1 Device Management Guide Page 363 of 411
Zobrazit stránku 362
1 2 ... 358 359 360 361 362 363 364 365 366 367 368 ... 410 411

Komentáře k této Příručce

Žádné komentáře