Allied-telesis AT-S94 CLI (AT-8000S Series) Uživatelský manuál stáhnout pdf (Strana 178)

100

101

Page 177

Allied Telesis

AT-8000S-S94-3.0 Command Line Interface User’s Guide

Command Mode

Global Configuration mode.

User Guidelines

There are no user guidelines for this command.

Example

The following example specifies the minimum time an LLDP port waits before reinitializing LLDP transmissions to

five seconds.

lldp tx-delay

The lldp tx-delay Global Configuration mode command specifies the delay between successive LLDP frame

transmissions initiated by value/status changes in the LLDP local systems MIB. Use the no form of this command

to revert to the default setting.

Syntax

lldp tx-delay seconds

no lldp tx-delay

Parameters

•

seconds — Specifies the delay, in seconds, between successive LLDP frame transmissions initiated by

value/status changes in the LLDP local systems MIB. (Range: 1 - 8192 seconds)

Default Configuration

The default value is 2 seconds.

Command Mode

Global Configuration mode.

User Guidelines

•

It is recommended that the TxDelay be less than 0.25 of the LLDP timer interval.

Example

The following example specifies the delay between successive LLDP frame transmissions initiated by value/status

changes in the LLDP local systems MIB to 10 seconds.

lldp optional-tlv

The lldp optional-tlv Interface Configuration mode command specifies which optional TLVs from the basic set

should be transmitted. Use the no form of this command to revert to the default setting.

console(config) # lldp reinit-delay 5

console(config) # lldp tx-delay 10

1 2 ... 173 174 175 176 177 178 179 180 181 182 183 ... 401 402

Komentáře k této Příručce

Žádné komentáře

Allied-telesis AT-S94 CLI (AT-8000S Series) Uživatelský manuál Strana 178

Komentáře k této Příručce

Související produkty a manuály pro Počítačový hardware Allied-telesis AT-S94 CLI (AT-8000S Series)