Allied-telesis AT-S94 CLI (AT-8000S Series) Uživatelský manuál stáhnout pdf (Strana 104)

100

101

Page 103

Allied Telesis

AT-8000S-S94-3.0 Command Line Interface User’s Guide

Command Mode

Interface Configuration (Ethernet, port-channel) mode

User Guidelines

The no speed command in a port-channel context returns each port in the port-channel to its maximum capability.

Example

The following example configures the speed operation of Ethernet port 1/e5 to 100 Mbps operation.

This document uses the following conventions to highlight important information:

Note

The speed setting for SFP ports is dependent on the maximum speed of the port.

duplex

The duplex Interface Configuration (Ethernet) mode command configures the full/half duplex operation of a given

Ethernet interface when not using auto-negotiation. Use the no form of this command to restore the default

configuration.

Syntax

duplex {half | full}

no duplex

Parameters

•

half — Forces half-duplex operation

• full — Forces full-duplex operation

Default Configuration

The interface is set to full duplex.

Command Mode

Interface Configuration (Ethernet) mode

User Guidelines

When configuring a particular duplex mode on the port operating at 10/100 Mbps, disable the auto-negotiation on

that port.

Half duplex mode can be set only for ports operating at 10 Mbps or 100 Mbps.

console(config)#

interface ethernet

1/e5

console(config-if)#

speed 100

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 401 402

Komentáře k této Příručce

Žádné komentáře

Allied-telesis AT-S94 CLI (AT-8000S Series) Uživatelský manuál Strana 104

Komentáře k této Příručce

Související produkty a manuály pro Počítačový hardware Allied-telesis AT-S94 CLI (AT-8000S Series)