Allied Telesis AT-SBX81XS6 Instalační příručka Strana 124

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 314
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 123
Chapter 6: Installing the Power Supplies
124 Section II: Installing the Chassis
8. Lower the locking handle of the power supply module to secure the
module in the slot, as shown in Figure 61.
Figure 61. Locking the Handle on the AT-SBxPWRSYS1 DC System
Power Supply
Do not tighten the handle locking screw yet. You may need to
slightly lift the handle to move the plastic guard panel when you
connect the positive and negative wires in “Powering On the AT-
SBxPWRSYS1 DC System Power Supply” on page 171.
9. To install a second AT-SBxPWRSYS1 DC System Power Supply,
repeat this procedure.
10. After installing the power supplies, go to Chapter 7, “Installing the AT-
SBx81CFC960 Control Card and Ethernet Line Cards” on page 125.
Retain the five wire ring lugs that come with the power supply. You
use them to wire the power supply in “Powering On the AT-
SBxPWRSYS1 DC System Power Supply” on page 171.
Zobrazit stránku 123
1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 313 314

Komentáře k této Příručce

Žádné komentáře