Allied-telesis AT-S95 CLI (AT-8000GS Series) Uživatelský manuál stáhnout pdf (Strana 326)

100

101

Page 326

Allied Telesis

AT-8000GS Command Line Interface User’s Guide

Example

This example changes Unit Number 6 to Unit Number 5. The command takes effect only after resetting the device.

show stack

The show stack User EXEC mode command displays information about the status of a stack.

Syntax

show stack [unit unit]

Parameters

•

unit — Specifies the number of the unit. (Range: 1 - 6)

Default Configuration

This command has no default configuration.

Command Mode

User EXEC mode

User Guidelines

This command is not relevant to standalone devices.

Example

The following example displays stack status..

console#

config

console(config)#

stack change unit-id

Console>

show stack

Unit MAC Address Software Master Uplink Downlink Status

---- ----------------- -------- -------- ------ -------- ------

1 00:15:77:74:64:40 v1.1.0.23 Enabled 2 3 Master

2 00:15:77:66:3e:80 v1.1.0.23 Enabled 3 1 Backup

3 00:01:02:03:04:05 v1.1.0.23 Disabled 1 2 Slave

Topology is Ring

Unit Unit Id After Reset

----

-------------

1 2 ... 321 322 323 324 325 326 327 328 329 330 331 ... 396 397

Komentáře k této Příručce

Žádné komentáře

Allied-telesis AT-S95 CLI (AT-8000GS Series) Uživatelský manuál Strana 326

Komentáře k této Příručce

Související produkty a manuály pro Počítačový hardware Allied-telesis AT-S95 CLI (AT-8000GS Series)