Allied-telesis AT-S95 CLI (AT-8000GS Series) Uživatelský manuál stáhnout pdf (Strana 119)

Ethernet Configuration Commands

Page 119

Parameters

This command has no arguments or keywords.

Default Configuration

Broadcast storm control is disabled.

Command Modes

Interface Configuration (Ethernet) mode

User Guidelines

Use the port storm-control broadcast rate Interface Configuration (Ethernet) mode command, to set the

maximum allowable Broadcast rate.

Use the port storm-control include-multicast Global Configuration mode command to enable counting

Multicast packets in the storm control calculation.

Examples

The following example enables Broadcast storm control on Ethernet port 1/g5.

port storm-control broadcast rate

The port storm-control broadcast rate Interface Configuration (Ethernet) mode command configures the

maximum Broadcast rate. Use the no form of this command to return to the default configuration.

Syntax

port storm-control broadcast rate rate

no port storm-control broadcast rate

Parameters

•

rate — Maximum kilobits per second of Broadcast and Multicast traffic on a port. (Range: 70 - 6000000

Default Configuration

The default storm control Broadcast rate is12,000Kbits/Sec.

Command Mode

Interface Configuration (Ethernet) mode

User Guidelines

Use the port storm-control broadcast enable Interface Configuration mode command to enable Broadcast

storm control.

The rate is rounded off to the nearest 64 Kbits/Sec (except for 1 - 63 Kbits/Sec which is rounded off to 64 Kbits/

Sec). If the rate is 0, Broadcast packets are not forwarded.

console(config)#

interface ethernet

1/g5

console(config-if)#

port storm-control broadcast enable

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 396 397

Žádné komentáře

Allied-telesis AT-S95 CLI (AT-8000GS Series) Uživatelský manuál Strana 119