Allied-telesis AT-SBx81CFC960 Uživatelský manuál stáhnout pdf (Strana 297)

SwitchBlade x8106 Chassis Switch and AT-SBx81CFC960 Card Installation Guide

Section III: Building a Stack with VCStack Plus 297

Setting the Priority Number

This procedure is optional. It explains how to set the stack priority number

on the chassis, which controls the selection of the active controller card for

the stack. For background information, refer to “Priority Numbers” on

page 279. If you do not want to set the priority number, go to “Powering Off

the Chassis” on page 298.

To configure the priority number, perform the following procedure:

1. Enter the CONFIGURE TERMINAL to move from the Privileged Exec

mode to the Global Configuration mode.

awplus# configure terminal

awplus(config)#

2. Enter the STACK PRIORITY command to set the priority number of

the chassis. The format of the command is as follows:

stack <ID_number> priority <priority_number>

The ID_number variable is the switch’s current ID number, displayed

with the SHOW STACK command. The priority_number variable is the

new priority number for the chassis. The range is 0 to 255. The lower

the number, the higher the priority. This example sets the priority

number of the chassis to 1:

awplus(config)# stack 1 priority 1

The switch displays the following prompt:

% Warning: Stacking is currently disabled.

3. Enter the EXIT command to return to the Privileged Exec mode:

awplus(config)# exit

awplus#

4. Enter the SHOW STACK command to confirm your change. Refer to

Figure 187 on page 296. The Priority column should now be displaying

the new priority number for the chassis.

5. Enter the COPY RUNNING-CONFIG command to save your change:

awplus# copy running-config startup-config

This completes the procedure for configuring the chassis for the stacking

feature. Go to “Powering Off the Chassis” on page 298.

1 2 ... 292 293 294 295 296 297 298 299 300 301 302 ... 321 322

Žádné komentáře

Allied-telesis AT-SBx81CFC960 Uživatelský manuál Strana 297