Allied Telesis Rapier 16Fi-FX Instalační příručka stáhnout pdf (Strana 22)

22 Power Over Ethernet Enhancements Release Note

Software Version 2.9.1

C613-10486-00 REV C

During the upgrade the following limitations apply:

■ Other PoE commands do not execute.

■ You cannot use any PoE ports for powered devices, as Power over Ethernet

is temporarily disabled. However, any non-powered devices that are

connected to PoE ports will continue to operate normally.

■ You should avoid deleting, re-naming, or copying any files.

All PoE configurations are restored once the upgrade has successfully

completed. You do not need to reconfigure PoE or restart the switch for the

new firmware to take effect.

The new firmware version is permanently stored in the PoE hardware. This

remains in the PoE hardware even if you delete the .sig file from flash memory.

Example To download the PoE firmware file v2.9.0 to the PoE Controller, use the

command:

set poe firm=pol30k.s19

show poe version

Syntax SHow POE VERsion

Description Use this command to display the version number of the PoE firmware that is

currently running on your AT-8600 Series switch.

Figure 1: Example output from the show poe version command

Example To display the PoE firmware version number, use the command:

sh poe ver

PoE version information:

Firmware version .... 2.9.0

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 282 283

Žádné komentáře

Allied Telesis Rapier 16Fi-FX Instalační příručka Strana 22