Allied Telesis Rapier 16Fi-FX Instalační příručka stáhnout pdf (Strana 21)

Software Version 2.9.1 21

Software Version 2.9.1

C613-10486-00 REV C

Examples To disable all PoE debugging, use one of the commands:

dis poe deb=all

dis poe debug=deb

To disable high-level, essential debugging, use the command:

dis poe deb=tra

enable poe debug

Description This new command enables the specified PoE debugging modes.

Example To enable error debugging, use one of the commands:

ena poe deb=err

ena poe deb=fat

set poe firmware

Syntax SET POE FIRMware=filename

where filename is the name of a valid firmware file that is already present in the

flash. A valid firmware file must be either Version 2.9.0 or 5.0.1, and have the

extension .s19.

Description This new command upgrades the PoE firmware in the PoE Controller, if the

AT-8600 Series switch finds valid PoE firmware in its flash. Firmware is

downloaded to the flash using the load command. See the Managing

Configuration Files and Software Versions chapter in the Software Reference for

command details.

The switch prompts you for confirmation before it begins upgrading the

firmware. The upgrade may take a while to complete, depending on the size of

your firmware file.

You must not restart the switch while the firmware upgrade is in progress. If

you restart the switch, the firmware upgrade will terminate abruptly, which will

corrupt the firmware and cause PoE operations to fail in the subsequent startup.

Parameter Description

DEBug The debugging modes to enable.

Default: all

ALL

DEBug

Enables all PoE debugging

TRAce Enables only high-level, essential debugging, for

example, information about message types

ERRor

FATal

Enables only the debugging of any error conditions that

may occur during PoE operation.

TESt Enables only the test debugging mode

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 282 283

Žádné komentáře

Allied Telesis Rapier 16Fi-FX Instalační příručka Strana 21