Allied-telesis AT-S95 CLI Uživatelský manuál stáhnout pdf (Strana 170)

Page 158

Not approved by Document Control. For review only.

Allied Telesis

Command Line Interface User’s Guide

no power inline powered-device

Parameters

•

pd-type—Specifies the type of powered device attached to the interface. (Range: 1-24 characters)

Default Configuration

This command has no default configuration.

Command Mode

Interface Configuration (Ethernet) mode

User Guidelines

There are no user guidelines for this command.

Example

The following example configures a description to an IP-phone to a powered device connected to Ethernet

interface 1/g1.

power inline priority

The power inline priority Interface Configuration (Ethernet) mode command configures the inline power

management priority of the interface. Use the no form of this command to return to the default configuration.

Syntax

power inline priority {critical | high | low}

no power inline priority

Parameters

•

critical — Indicates that operating the powered device is critical.

• high — Indicates that operating the powered device has high priority.

• low—Indicates that operating the powered device has low priority.

Default Configuration

The default setting is low priority.

Command Mode

Interface Configuration (Ethernet) mode

User Guidelines

There are no user guidelines for this command.

Console(config)# interface ethernet 1/g1

Console(config-if)#

power inline powered-device

IP-phone

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 347 348

Žádné komentáře

Allied-telesis AT-S95 CLI Uživatelský manuál Strana 170