Allied-telesis AT-S95 CLI Uživatelský manuál Strana 167

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 348
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 166
Port Monitor Commands
Page 155
Chapter 18.Port Monitor Commands
port monitor
The port monitor Interface Configuration mode command starts a port monitoring session. Use the no form of
this command to stop a port monitoring session.
Syntax
port monitor src-interface [rx | tx]
no port monitor src-interface
Parameters
src-interface—Valid Ethernet port. (Full syntax: unit/port)
rxMonitors received packets only.
txMonitors transmitted packets only.
Default Configuration
Monitors both received and transmitted packets.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command enables traffic on one port to be copied to another port, or between the source port (src-interface)
and a destination port (port being configured).
The following restrictions apply to ports configured as destination ports:
The port cannot be already configured as a source port.
The port cannot be a member in a port-channel.
An IP interface is not configured on the port.
GVRP is not enabled on the port.
The port is not a member of a VLAN, except for the default VLAN (will automatically be removed from the default
VLAN).
The following restrictions apply to ports configured to be source ports:
The port cannot be already configured as a destination port.
Example
The following example copies traffic on port 1/g8 (source port) to port 1/g1 (destination port).
Console(config)#
interface ethernet 1/g1
Console(config-if)#
port monitor
1/g8
Zobrazit stránku 166
1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 347 348

Komentáře k této Příručce

Žádné komentáře