Allied-telesis AlliedWare Plus Operating System Version 5.4.4C (x Uživatelský manuál stáhnout pdf (Strana 35)

Getting Started

Software Reference for x310 Series Switches

C613-50046-01 REV A AlliedWare Plus

Operating System - Version 5.4.4C 1.11

Default Settings

When the switch first starts up with the AlliedWare Plus

OS, it applies default settings

and copies these defaults dynamically into its running-config.

These default settings mean that the AlliedWare Plus

OS:

■ encrypts passwords, such as user passwords

■ records log message priority in log messages

■ turns on the telnet server so that you can telnet to the switch

■ enables the switch to look up domain names (but for domain name lookups to work,

you have to configure a DNS server)

■ turns off L3 multicast packet switching in the switch’s hardware. This prevents L3

multicast from flooding the switch’s CPU in its default state as an L2 switch

■ sets the maximum number of ECMP routes to 4

■ turns on RSTP on all ports. Note that the ports are not set to be edge ports

■ sets all the switch ports to access mode. This means they are untagged ports, suitable

for connecting to hosts

■ creates VLAN 1and adds all the switch ports to it

■ allows logins on the serial console port

■ allows logins on VTY sessions (for telnet etc)

■ has switching enabled, so Layer 2 traffic is forwarded appropriately without further

configuration

■ allocates all the routing table memory space to IPv4 and IPv6 routes

■ has ports set to autonegotiate their speed and duplex mode

■ has copper ports set to auto MDI/MDI-X mode

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 221 222

Žádné komentáře

Allied-telesis AlliedWare Plus Operating System Version 5.4.4C (x Uživatelský manuál Strana 35