Allied-telesis AlliedWare Plus Operating System Version 5.4.4C (x Uživatelský manuál stáhnout pdf (Strana 218)

System Configuration and Monitoring Commands

Software Reference for x310 Series Switches

8.18 AlliedWare Plus

Operating System - Version 5.4.4C C613-50046-01 REV A

hostname

This command sets the name applied to the device as shown at the prompt. The

hostname is:

■ displayed in the output of the show system command

■ displayed in the CLI prompt so you know which device you are configuring

■ stored in the MIB object sysName

On a stack, after the stack master is elected, the master will have a host name: awplus by

default, and this also becomes the name of the stack. Individual stack members (excluding

the master) will have a host name that is the stack name hyphenated with a numeric suffix.

For example, awplus-1, awplus-2 and so on.

The hostname command can then be used to change the stack name and the stack

master's host name. For example, for the hostname Lab the stack master’s host name will

be Lab and the other stack members will have host names Lab-1, Lab-2 and so on.

In case of stack master fail-over, or stack split, the new stack will use the previous stack

name as its host name and the stack name, unless it is changed by executing the

hostname command on the new stack master.

Use the no variant of this command to revert the hostname setting to its default

(awplus).

Syntax hostname <hostname>

no hostname [<hostname>]

Default

awplus

Mode Global Configuration

Usage The name must also follow the rules for ARPANET host names. The name must start with a

letter, end with a letter or digit, and use only letters, digits, and hyphens. Refer to RFC

1035.

Example To set the system name to HQ-Sales, use the command:

Parameter Description

Specifies the name given to a specific switch. Also referred to as the

Node Name in AMF output screens.

Note

Within an AMF network, any switch without a hostname applied will

automatically be assigned a name based on its MAC address.

To efficiently manage your network using AMF, we strongly advise that you

devise a naming convention for your network switches and accordingly apply

an appropriate hostname to each switch.

awplus#

configure terminal

awplus(config)#

hostname HQ-Sales

1 2 ... 213 214 215 216 217 218 219 220 221 222

Komentáře k této Příručce

Žádné komentáře

Allied-telesis AlliedWare Plus Operating System Version 5.4.4C (x Uživatelský manuál Strana 218

Komentáře k této Příručce

Související produkty a manuály pro Počítačový hardware Allied-telesis AlliedWare Plus Operating System Version 5.4.4C (x