Allied-telesis AlliedWare Plus Operating System Version 5.4.4C (x Uživatelský manuál stáhnout pdf (Strana 151)

File Management Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A AlliedWare Plus

Operating System - Version 5.4.4C 7.5

Command List

autoboot enable

This command enables the device to restore a release file and/or a configuration file from

external media, such as a USB storage device.

When the Autoboot feature is enabled, the device looks for a special file called

autoboot.txt on the external media. If this file exists, the device will check the key and

values in the file and recover the device with a new release file and/or configuration file

from the external media. An example of a valid autoboot.txt file is shown in

Figure 7-1 below.

Figure 7-1: Example autoboot.txt file

Use the no variant of this command to disable the Autoboot feature.

Syntax autoboot enable

no autoboot enable

Default

The Autoboot feature operates the first time the device is powered up in the field, after

which the feature is disabled by default.

Mode Global Configuration

Example To enable the Autoboot feature, use the command:

To disable the Autoboot feature, use the command:

Related Commands create autoboot

show autoboot

show boot

[AlliedWare Plus]

Copy_from_external_media_enabled=yes

Boot_Release=x310-5.4.4C.rel

Boot_Config=network1.cfg

Note

This command is not supported in a stacked configuration.

awplus#

configure terminal

awplus(config)#

autoboot enable

awplus#

configure terminal

awplus(config)#

no autoboot enable

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 221 222

Žádné komentáře

Allied-telesis AlliedWare Plus Operating System Version 5.4.4C (x Uživatelský manuál Strana 151