Allied-telesis AT-FS708 Uživatelský manuál stáhnout pdf (Strana 30)

Chapter 2: Installation

Cabling the Switch

To connect the twisted pair cables to the ports on the AT-FS708 switch,

perform the following procedure:

1. Connect the twisted pair data cables to the RJ-45 ports on the switch,

as shown in Figure 8.

Figure 8. Connecting the Twisted Pair Data Cables

When connecting a twisted pair cable to a port, observe the following

guidelines:

 An RJ-45 connector should fit snugly into the port on the switch.

The tab on the connector should lock the connector into place.

 The ports on the switch are auto-MDI/MDI-X. You can use a

straight-through twisted pair cable to connect any type of network

device to a port on the switch.

 The network should not contain data loops, which can adversely

affect network performance. A data loop exists when two or more

network devices can communicate with each other over more than

one data path.

1234 6785

AUTO MDI/MDI-X

1774

1 2 ... 25 26 27 28 29 30 31 32 33 34 35

Žádné komentáře

Allied-telesis AT-FS708 Uživatelský manuál Strana 30