Allied Telesis AT-S94 Uživatelská příručka stáhnout pdf (Strana 155)

Configuring Multicast Forwarding

Page 155

To define Multicast Groups:

1. Click Multicast > Multicast Group. The Multicast Group Page opens:

Figure 102:Multicast Group Page

The Multicast Group Page contains the following fields:

• Enable Bridge Multicast Filtering — Indicates if bridge Multicast filtering is enabled on the device.

The possible field values are:

– Checked — Enables Multicast filtering on the device.

– Unchecked — Disables Multicast filtering on the device. If Multicast filtering is disabled, Multicast frames

are flooded to all ports in the relevant VLAN. Disabled is the default value.

• VLAN ID — Displays the VLAN for which Multicast parameters are displayed.

• Bridge Multicast Address — Identifies the Multicast group MAC address/IP address.

• Select the interfaces displayed in the table.

– Ports of Unit — Specifies the port and stacking member for which the Multicast group settings are

displayed.

– Trunk — Specifies the trunk for which the Multicast group settings are displayed.

• Interface — Displays the currently defined interface.

• Interface Status — Displays the current interface status. Available options are: excluded, forbidden, static

and dynamic.

2. Check the Enable Bridge Multicast Filtering checkbox.

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 253 254

Žádné komentáře

Allied Telesis AT-S94 Uživatelská příručka Strana 155