Allied Telesis AR450S Uživatelská příručka Strana 73

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 119
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 72
Physical and Layer 2 Interfaces 73
Software Release 2.5.2
C613-02034-00 REV A
Default Setup
The standard LAPD configurations are shown in Table 8 on page 73 (Basic Rate
Interfaces) and Table 9 on page 73 (Primary Rate Interfaces). These settings suit
many situations. However, you can modify these settings as required to suit
other network situations (see the Integrated Services Digital Network (ISDN)
chapter, AR400 Series Router Software Reference).
Testing the BRI or PRI PIC
To test the ISDN PRI, BRI (U), or BRI (S/T) PIC you need to configure a routing
protocol such as IP or IPX to use ISDN.
For more information about configuring ISDN calls and routing protocols, see
Configuring ISDN (AR410 only)” on page 74, “Configuring an IP Network” on
page 83, and “Configuring a Novell IPX Network” on page 95.
Table 8: Standard LAPD configuration for an ISDN Basic Rate Interface.
Mode Auto
Debug Off
TEI Provided by the network
T, N and k values (for each SAPI):
SAPI Layer 3 T200 T201 T202 T203 N200 N201 N202 k
0 Q.931 Call Control 10 10 20 100 3 260 3 1
1 Q.931 Packet Mode 10 10 20 100 3 260 3 3
16 X.25 Packet Mode 10 10 20 100 3 1024 3 3
63 LAPD Management 10 10 20 100 3 260 3 1
Table 9: Standard LAPD configuration for an ISDN Primary Rate Interface.
Mode nonAuto
Debug Off
TEI 0
T, N and k values (for each SAPI):
SAPI Layer 3 T200 T201 T202 T203 N200 N201 N202 k
0 Q.931 Call Control 10 N/A N/A 100 3 260 N/A 7
1 Q.931 Packet Mode 10 N/A N/A 100 3 260 N/A 7
16 X.25 Packet Mode 10 N/A N/A 100 3 1024 N/A 7
63 LAPD Management 10 N/A N/A 100 3 260 N/A 7
Zobrazit stránku 72
1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 118 119

Komentáře k této Příručce

Žádné komentáře