Allied-telesis x510 Series Uživatelský manuál stáhnout pdf (Strana 91)

x510 Series Installation Guide for Virtual Chassis Stacking

Figure 43. Plugging in the AC Power Cords

Consider the following items as you power on the switch:

 Connecting the two power cords to power sources that are on

different circuits will provide power redundancy to the switch in the

event a circuit fails.

 Refer to “Power Specifications” on page 116 for the power

specifications of the switches.

Warning

Power cord is used as a disconnection device. To de-energize

equipment, disconnect the power cord.  E3

Note

Pluggable Equipment. The socket outlet shall be installed near the

equipment and shall be easily accessible.  E5

2. Wait one minute for the switch to initialize its management software.

The switch should be displaying the number 1 on its ID LED.

3. Power on the switch to be assigned ID number 2.

4. Wait two minutes for the new switch to join the stack as a member.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 121 122

Žádné komentáře

Allied-telesis x510 Series Uživatelský manuál Strana 91