Allied-telesis x310 Series Uživatelský manuál stáhnout pdf (Strana 90)

Chapter 5: Cabling the Networking Ports

Note

If you are ready to attach the fiber optic cable to the transceiver,

continue with the next step. Otherwise, repeat steps 1 to 4 to install

another SFP transceiver in the switch.

5. Remove the dust cover from the transceiver, as shown in Figure 42.

Figure 42. Removing the Dust Cover from an SFP Transceiver

6. Verify the position of the handle on the SFP transceiver. If the

transceiver is in a top slot, the handle should be in the upright position,

as shown in Figure 43. If the transceiver is in a bottom slot, the handle

should be in the down position.

Figure 43. Positioning the SFP Handle in the Upright Position

SFP Handle

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 115 116

Žádné komentáře

Allied-telesis x310 Series Uživatelský manuál Strana 90