Allied-telesis SwitchBlade x8106 Uživatelský manuál stáhnout pdf (Strana 167)

SwitchBlade x8106 Chassis Switch Installation Guide

167

Connecting the

DC Power Wires

with the Right

Angle Terminals

To connect the DC power wires to the positive and negative terminals on

the power supply with the right angle terminals, perform the following

procedure:

1. Prepare adequate lengths of two stranded 8 AWG power wires by

stripping them as shown in Figure 122.

Warning

Do not strip more than the recommended amount of wire. Stripping

more than the recommended amount can create a safety hazard by

leaving exposed wire on the terminal block after installation.  E10

Figure 122. Stripping the Power Wires

Note

You must use stranded wires with the terminal lugs. You may not

use solid wires.

2. Verify that the On/Off switch on the AT-SBxPWRSYS1 DC Power

Supply is in the Off position. Refer to Figure 115 on page 160.

3. Insert the power wires into the right angle terminals included with the

power supply and use a crimping tool to secure the wires to the

terminals. See Figure 123,

Figure 123. Attaching the Power Wires to the Right Angle Terminals

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 239 240

Žádné komentáře

Allied-telesis SwitchBlade x8106 Uživatelský manuál Strana 167