Allied-telesis SwitchBlade x8106 Uživatelský manuál Strana 162

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 240
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 161
Chapter 7: Powering On the Chassis
162
Figure 117. Removing the Terminal Screws
6. With a #3 Phillips-head screwdriver, connect the positive (+) power
lead wire to the positive terminal on the power supply, with one of the
terminal screws removed in the previous step. The positive terminal is
on the left. You may attach the terminals with the wires either above or
below the terminal block. Figure 118 on page 163 shows the positive
wire above the terminal block.
Allied Telesis recommends tightening the screw to 30 to 40 inch-lbs.
Zobrazit stránku 161
1 2 ... 157 158 159 160 161 162 163 164 165 166 167 ... 239 240

Komentáře k této Příručce

Žádné komentáře