Allied-telesis AT-S62 Uživatelský manuál stáhnout pdf (Strana 51)

100

101

AT-S62 Command Line User’s Guide

SET IP INTERFACE

Syntax

set ip interface=1 ipaddress=ipaddress|DHCP

mask|netmask=subnetmask

Parameters

interface Specifies the interface number. This value is always

ipaddress Specifies an IP address for the switch or activates the

DHCP and BOOTP client software.

mask Specifies the subnet mask for the switch. You must

netmask specify a subnet mask if you manually assigned the

switch an IP address. These parameters are

equivalent.

Description

This command configures the following switch parameters:

❑ IP address

❑ Subnet mask

This command can also activate the DHCP and BOOTP client software on

the switch. Activating DHCP and BOOTP with this command is

equivalent to using ENABLE DHCPBOOTP on page 40 or ENABLE IP

REMOTEASSIGN on page 41.

Note

You cannot assign an IP address to the switch if the DHCP and

BOOTP client software is activated.

To display the current IP address and subnet mask, refer to SHOW IP

INTERFACE on page 60. To return the IP address and subnet mask to

their default values, refer to PURGE IP on page 44.

For background information on when to assign a switch an IP address,

refer to the AT-S62 Management Software User’s Guide.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 419 420

Komentáře k této Příručce

Žádné komentáře

Allied-telesis AT-S62 Uživatelský manuál Strana 51

Komentáře k této Příručce

Související produkty a manuály pro Počítačový hardware Allied-telesis AT-S62