Allied-telesis AT-S62 Uživatelský manuál stáhnout pdf (Strana 181)

100

101

AT-S62 Command Line User’s Guide

181

Note

Before creating a port trunk, examine the speed, duplex mode, and

flow control settings of the lowest numbered port to be in the trunk.

Check to be sure that the settings are correct for the end node to

which the trunk will be connected. When you create the trunk, the

AT-S62 management software copies the settings of the lowest

numbered port in the trunk to the other ports so that all the settings

are the same.

You should also check to be sure that the ports are untagged

members of the same VLAN. You cannot create a trunk of ports that

are untagged members of different VLANs.

Examples

The following command creates a port trunk using ports 3 through 6.

The command names the trunk “load22” and sets the load distribution

method to destination MAC address.

create switch trunk=load22 port=3-6 select=macdest

The following command creates a port trunk consisting of ports 15,17,

and 23. The command names the trunk “trunk4”. No load distribution

method is specified, so the default source and destination MAC

addresses is used:

create switch trunk=trunk4 port=15,17,23

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 419 420

Komentáře k této Příručce

Žádné komentáře

Allied-telesis AT-S62 Uživatelský manuál Strana 181

Komentáře k této Příručce

Související produkty a manuály pro Počítačový hardware Allied-telesis AT-S62