Allied-telesis AT-FS970M Series Uživatelský manuál Strana 324

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 330
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 323
Chapter 26: sFlow
324
Specifying an sFlow Collector
Use this procedure to specify the IP address and the UDP port of an sFlow
collector on your network. The packet sampling data and the packet
counters are sent by the switch to the collector specified. You can specify
only one collector.
To select the Collector tab from the sFlow page, do the following:
1. Hover the cursor over the Discovery & Monitoring tab.
The Discovery & Monitoring tab is displayed. See Figure 143.
Figure 143. Discovery & Monitoring Tab
2. From the Discovery & Monitoring tab drop-down menu, select
sFlow.
The sFlow page is displayed with the Port Configurations tab selected.
See Figure 144.
Figure 144. sFlow Page with the Port Configurations Tab
3. From the sFlow page, select the Collector tab.
Zobrazit stránku 323

Komentáře k této Příručce

Žádné komentáře