Allied-telesis AT-9448Ts/XP (Basic Layer 3) Uživatelský manuál stáhnout pdf (Strana 56)

Chapter 3: Preparing the Switches

3. The new module ID number does not take affect until the switch is

reset. Reset the unit with this command:

restart reboot

4. Wait for the switch to reset and afterwards reestablish the

management session by logging in again.

5. Enter the following command again to verify the switch’s stack ID

assignment:

show stack

6. Verify that the Stack Mode is Static and the Stack ID is 1. If the values

are correct, go to the next step. Otherwise, repeat the procedure

starting with step 2.

7. Power off the switch.

Repeat the procedures in this chapter on the other switches of the stack.

Afterwards, go to the next chapter for instructions on how to cable and

power on the stack.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 105 106

Žádné komentáře

Allied-telesis AT-9448Ts/XP (Basic Layer 3) Uživatelský manuál Strana 56