Allied-telesis AT-9448Ts/XP (Basic Layer 3) Uživatelský manuál stáhnout pdf (Strana 50)

Chapter 3: Preparing the Switches

Powering on a Switch

To power on a switch, perform the following procedure:

1. Position the power cord retaining clip in the up position, as shown in

Figure 19.

Figure 19. Power Cord Retaining Clip in the Up Position

2. Plug the power cord into the AC power connector on the back panel of

the unit (see Figure 20).

Figure 20. Connecting the AC Power Cord

Warning: Power cord is used as a disconnection device. To de-

energize equipment, disconnect the power cord.



Warning: This unit might have more than one power cord. To

reduce the risk of electric shock, disconnect all power cords

before servicing the unit.



100-240VAC

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 107 108

Žádné komentáře

Allied-telesis AT-9448Ts/XP (Basic Layer 3) Uživatelský manuál Strana 50