Allied-telesis AR700 SERIES Software Release 2.7.1 Uživatelský manuál stáhnout pdf (Strana 101)

101

Software Release 2.7.1

C613-02047-00 REV A

Configuring IPX Dial-on-Demand

This example (Figure 16) illustrates how to set up the router to provide a wide

area internet based on Novell’s IPX routing protocol with dial-on-demand

access. In this scenario, a PC at a remote site periodically accesses the Novell

file server at a central site to read Email, transfer files or print documents on a

laser printer. The two sites are connected by a PPP link over a wide area link—

either a dedicated leased line or an ISDN call.

Figure 16: Example configuration for an IPX dial-on-demand network.

To configure IPX dial-on-demand follow these steps

If the PPP link uses an ISDN call configured as a dial-on-demand link (see

“Configuring ISDN Dial on Demand” on page 81), then you can configure IPX

for IPX dial-on-demand services.

The following steps are required:

1. Clear the previous IPX configuration.

2. Enable IPX.

3. Define the IPX circuits.

4. Save the configuration.

UGIPX2_R

Network = 401

Netware

File Server

Network = 12

Remote PC

Head Office Router

Remote Office Router

PPP Data Link

Network = 129

Table 14: Example configuration parameters for IPX dial-on-demand.

Parameter Head Office Router Remote Office Router

Ethernet interface eth0 eth0

Ethernet encapsulation 802.3 802.3

Novell network number for Ethernet 401 12

IPX circuit over Ethernet 1 1

PPP interface ppp0 ppp0

Novell network number for PPP 129 129

IPX circuit over PPP 2 2

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 117 118

Žádné komentáře

Allied-telesis AR700 SERIES Software Release 2.7.1 Uživatelský manuál Strana 101