Allied-telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT Uživatelský manuál stáhnout pdf (Strana 261)

100

101

AlliedView™-EMS 3.10 Device Management Guide Page 261 of 367

will result in the error message: ”The error occurred with 'Set' operation. Error:

bad value.”

Server Info

Displays information about servers.

Note - The current firmware version does not allow the Authentication Key

parameter to be configured.

Note - The only valid MIB Set value for the Row Status parameter is ‘destroy’.

Attempting to set this parameter to any other value will result in the error

message: ”The error occurred with 'Set' operation. Error: bad value.”

Access Control List

Ethernet Info

Displays ACL mask of Ethernet information.

Note - The current firmware version does not allow the following parameters to be

configured:

o Filtered Ports

o Source MAC Address Mask

o Destination MAC Address Mask

Ethernet Rule

Displays ACL rule of Ethernet information.

Note - The current firmware version does not allow the following parameters to be

configured:

o VLAN

o Source MAC Address

o Destination MAC Address

o Ethernet Type

IP Info

Displays ACL mask of IP information.

Note - The current firmware version does not allow the following parameters to be

configured:

o Filtered Ports

o TCP/UDP Source Port Mask

o TCP/UDP Destination Port Mask

o Protocol ID Mask

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 366 367

Komentáře k této Příručce

Žádné komentáře

Allied-telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT Uživatelský manuál Strana 261

Komentáře k této Příručce

Související produkty a manuály pro Počítačový hardware Allied-telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT