Allied-telesis AT-S24 Uživatelský manuál stáhnout pdf (Strana 62)

Managing a Switch

Pinging a Device

The ping command allows you to test if an end system can be reached

by sending it an Internet control message protocol (ICMP) echo request.

If the system is connected to the network and operating, it sends a reply

to the requesting system.

To ping another device, perform the following procedure:

1. From the Omega Main Menu, select Administration.

2. From the Administration menu, select Ping a remote system.

The Ping window in Figure 23 is displayed.

Figure 23 Ping Window

3. Specify the device to ping using one of the following methods:

❑ By its IP address, in the format x.x.x.x

❑ By its Ethernet (or MAC) address, in the format xxxxxx xxxxxx

If you are pinging another Allied Telesyn switch, you can find the

switch’s MAC address above the RS232 management port on the

front panel of the switch.

The activity monitor reports the results of the ping command. Figure

24 is an example.

Figure 24 Ping Results Example

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 163 164

Žádné komentáře

Allied-telesis AT-S24 Uživatelský manuál Strana 62