Allied-telesis AT-S100 Uživatelský manuál Strana 79

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 274
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 78
AT-S100 Management Software User’s Guide
Section I: Command Modes 79
CONFIGURE TERMINAL
Syntax
configure terminal
Parameters
none
Description
Use this command to enter the Configuration Terminal command mode.
After you enter this command, the command prompt changes to
“(config)#” to indicate the new mode.
To exit the Configure Terminal command mode, enter EXIT or CTRL Z.
For a description of the Configuration Terminal mode, see “Configuration
Terminal Mode” on page 19. For information about the commands in the
Configuration Terminal mode, see Chapter 4, “Configuration Terminal
Mode Commands” on page 115.
Note
It is not necessary to enter the full command. You can abbreviate
this command to “config t.”
Command Mode
Privileged Executive mode
Examples
To enter the Configure Terminal command mode, enter the following
command:
switch#configure terminal
The prompt changes to:
Switch(config)#
Zobrazit stránku 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 273 274

Komentáře k této Příručce

Žádné komentáře