Allied-telesis AT-S100 Uživatelský manuál stáhnout pdf (Strana 64)

Chapter 2: Configuring the AT-S100 Software

The syntax of this command is:

show spanning-tree

To display the current spanning tree settings for the STP mode, enter the

following commands:

switch# configure terminal

switch(config)# spanning-tree mode stp

switch(config)# show spanning-tree

For more information about this command including a display, see “SHOW

SPANNING-TREE” on page 244.

Enabling or Disabling the Spanning Tree Mode

To enable or disable the spanning tree mode on the switch, use the

SPANNING-TREE ENABLE FORWARD command. The syntax of this

command is:

spanning-tree stp|rstp enable forward

To enable STP, enter the following commands:

switch# configure terminal

switch(config)# spanning-tree stp enable forward

To disable the RSTP on the switch, enter the following commands:

switch# configure terminal

switch(config)# no spanning-tree rstp enable forward

For more information about this command, see “SPANNING-TREE

ENABLE FORWARD” on page 247.

Setting Spanning-Tree Priority

Use the SPANNING-TREE PRIORITY command to specify the interface

priority for the switch. A lower priority value indicates a greater likelihood

of becoming a root. The default value is 32,768.

The syntax of this command is:

spanning-tree priority (0-61440)

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 273 274

Žádné komentáře

Allied-telesis AT-S100 Uživatelský manuál Strana 64