Allied-telesis AT-MCM02 Uživatelský manuál stáhnout pdf (Strana 19)

Chapter 3

Configuring the Management Module

After you have installed the AT-MCM02 Management Module in the media

converter, you must assign it an IP address, a subnet mask, and a gateway

address. You must also connect the management module to the network.

Note

You must perform this procedure if you intend to manage the media

converter using Telnet or SNMP. This procedure is not necessary if you

will be managing the media converter only through the RS-232 port on

the front panel of the media converter.

To configure the management module, perform the following procedure:

1. Connect the miniDIN end of the control cable to the Management RS-232

port on the front panel of the media converter.

2. Connect the other end of the control cable to a DB9 (male) connector on a

terminal or a PC with a terminal emulation program.

3. Configure the terminal or the terminal emulation program to the

following settings:

❑ Baud rate: 38400

❑ Parity: None

❑ Start bits: 1

❑ Stop bits: 1

❑ Flow control: None

❑ Emulator: VT100

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 51 52

Žádné komentáře

Allied-telesis AT-MCM02 Uživatelský manuál Strana 19