Allied-telesis AT-MCF2000S Uživatelský manuál stáhnout pdf (Strana 19)

AT-MCF2000S Stacking Module Installation Guide

Note

Do not remove the blank panel from the chassis until you are

ready to install a module. An open slot allows dust to enter

the unit and hinders the ability of the chassis to maintain

proper airflow and cooling.

3. Remove the tape from the DIP switch.

4. Set the chassis ID of the stacking module. Use the tip of a

ballpoint pen to change the setting of the DIP switch. See

Figure 3 on page 20. The chassis ID can be from 1 through

30. The default value is 1.

Use the table of DIP switch settings that is printed on the

module to determine the new chassis ID. Use the switches

labeled 1 through 5.

Caution

You cannot use the switch labeled 6.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Žádné komentáře

Allied-telesis AT-MCF2000S Uživatelský manuál Strana 19