Allied-telesis AT-GS924 Uživatelský manuál stáhnout pdf (Strana 29)

AT-GS916 and AT-GS924 Gigabit Ethernet Switches Installation Guide

Cabling the Switch

To connect to the ports on the AT-GS916 and AT-GS924 switches,

perform the following procedure:

1. Connect the twisted pair data cables to the RJ-45 ports on the switch,

as illustrated in Figure 13.

Figure 13 Connecting the Twisted Pair Data Cables

2. Power on the end-nodes. For more information, refer to ”Powering

On the Switch” on page 30.

When connecting a twisted pair cable to a port, observe the

following guidelines:

 An RJ-45 connector should fit snugly into the port on the switch.

The tab on the connector should lock the connector into place.

 The ports on the switch are auto-MDI/MDI-X. You can use either a

straight-through or crossover twisted pair cable to connect any

type of network device to a port on the switch.

 The network should not contain data loops, which can adversely

affect network performance. A data loop exists when two or more

network devices can communicate with each other over more

than one data path.

6 8

ACT

FDX

100

1000

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 49 50

Žádné komentáře

Allied-telesis AT-GS924 Uživatelský manuál Strana 29