Allied Telesis Switch AT-9000/28 Uživatelský manuál stáhnout pdf (Strana 38)

Chapter 3: Basic Switch Parameters

Setting a Telnet or SSH Server

The AlliedWare Plus Web Browser interface allows you to configure the

switch as a Telnet or SSH server.

You can use the web browser interface to enable a Telnet server, but not

as a Telnet client. The Telnet client is only supported from local

management sessions of the switch. For information about how to use a

Telnet client, see the AlliedWare Plus Management Software Command

Line Interface User’s Guide. See Where to Find Management Software

Updates and Product Information on page 13.

To enable an SSH server in the web interface, you must first create an

encryption key in the CLI interface. Then you can enable the SSH server

in the web interface.

The procedures in this section allow you to configure the switch as a

Telnet or SSH server.

To assign the switch to a Telnet or SSH server, do the following:

1. From the home page, select the System tab.

The System Settings tab is displayed. See Figure 6 on page 33.

2. From the System Settings tab, select Services.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 247 248

Žádné komentáře

Allied Telesis Switch AT-9000/28 Uživatelský manuál Strana 38