Allied Telesis Broadcom Advanced Control Suite 3 Uživatelská příručka stáhnout pdf (Strana 76)

Chapter 2: Configuring Teaming

To specify different values, click the desired probe interval in the

Probe interval (seconds) list and click the desired maximum number

of probe retries in the Probe maximum retries list.

Figure 37. Manage Teams Page: Edit Teams Tab

7. Set the Probe VLAN ID to correspond with the VLAN where the probe

target(s) resides.

This step applies the appropriate VLAN tag to the link packet based on

the shared configuration of the attached switch port(s).

Note

Each LiveLink enabled team can only communicate with Probe

Targets on a single VLAN. Also, VLAN ID 0 is equivalent to an

untagged network.

8. Select Probe Target 1 and type the target IP address for one or all of

the probe targets.

1 2 ... 71 72 73 74 75 76 77 78 79 80

Žádné komentáře

Allied Telesis Broadcom Advanced Control Suite 3 Uživatelská příručka Strana 76