Allied Telesis AR450S Uživatelský manuál stáhnout pdf (Strana 41)

Switching on the AR440S, AR441S and AR450S SHOW SWITCH PORT 3-41

Software Release 2.6.6

C613-03079-00 REV A

Example To display the configuration for switch port 1, use the command:

SHOW SWITCH PORT=1

Related Commands SET SWITCH PORT

Table 3-17: Parameters in the output of the SHOW SWITCH PORT

command .

Parameter Meaning

Port The number of the switch port.

Description A description of the port.

Status The state of the port; one of “ENABLED” or “DISABLED”.

Link state The link state of the port, one of “Up” or “Down”.

Uptime The count in hours:minutes:seconds of the elapsed time

since the port was last reset or initialised.

Configured speed/duplex The port speed mode configured for this port. One of

“Autonegotiate” or a combination of a speed (one of “10

Mbps” or “100 Mbps”) and a duplex mode (one of “half

duplex” or “full duplex”) and optionally “(by

autonegotiation)”.

Actual speed/duplex The port speed and duplex mode that this port is actually

running at. A combination of a speed (one of “10 Mbps”

or “100 Mbps”) and a duplex mode (one of “half duplex”

or “full duplex”).

Automatic MDI/MDI-X The state of the automatic MDI/MDI-X command; one of

“Disabled” or “Enabled”.

Configured MDI/MDI-X The configured polarity of the port; one of “MDI” or

“MDI-X”.

Actual MDI/MDI-X The actual polarity of the port; one of “MDI” or “MDI-X”.

Broadcast rate limit The limit of the rate of reception of broadcast frames for

this port, in Kbps.

Multicast cast rate limit The limit of the rate of reception of multicast frames for this

port, in Kbps.

DLF rate limit The limit of the rate of reception of DLF (destination lookup

failure) frames for this port, in Kbps.

Flow control(s) Flow control parameters set for the port; one of “Enabled”

or “Disabled”. If flow control is implemented, then flow

control is applied to the port.

Send tagged pkts for VLAN(s) The name and VLAN Identifier (VID) of the tagged VLAN(s),

if any, to which the port belongs.

Port-based VLAN The name and VLAN Identifier (VID) of the port-based

VLAN to which the port belongs.

Ingress Filtering The state of Ingress Filtering: one of “ON” or “OFF”.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 47 48

Komentáře k této Příručce

Žádné komentáře

Allied Telesis AR450S Uživatelský manuál Strana 41

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Allied Telesis AR450S