Allied Telesis AT-iMG7x6MOD series Instalační manuál stáhnout pdf (Strana 16)

AT-iMG746MOD Installation Guide

16 Chapter 3: Installing the Gateway in the Enclosure

Note

Store the packaging material in a safe location. You must use the original shipping material if you need

to return the unit to Allied Telesis.

 AT-iMGxx6MOD chassis (LAN and WAN cards are already installed)

 This Installation Guide

 Accessory Kit that includes:

– 2 #8-32 SEMS pan head Phillips screws

– 6-pin DC terminal block

Installing the Electronics Unit into the Enclosure

To install the gateway, perform the following procedure:

1. Open the enclosure and locate the notches at the top of the enclosure.

2. Align the tabs on top of the gateway with the notches at the top of the Enclosure. Then rest the gateway

on the ground plate rest and the two side rests of Enclosure. Refer to Figure 5.

Figure 5. Sliding the gateway into the Enclosure (Tabs into the Notches)

Warning: This unit is intended for installation in a restricted

access location. A restricted access location in where access

can only be gained by authorized service personnel through the

use of a special tool, lock and key, or other means of security,

and is controlled by the authority responsible for that location.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 55 56

Žádné komentáře

Allied Telesis AT-iMG7x6MOD series Instalační manuál Strana 16