Allied Telesis AT-FS705LE Instalační příručka Strana 31

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 46
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 30
AT-FS705LE Installation Guide
17
If the LINK/ACT LED is OFF, do the following:
Check to be sure that the end-node
connected to the port on the switch is
powered ON. If the end-node is OFF,
power the unit ON.
Check that the cable is securely connected
to the port on the switch and on the end-
node.
Check to be sure that the distance
between the switch and the end-node does
not exceed 100 meters (328 feet).
Check to be sure that you are using
Category 5 cable.
Check to be sure that the cable has not
been cut or damaged.
If there is a communication problem between
the end-nodes connected to the switch, do the
following:
Verify that the switch and end-nodes are
operating with the same duplex mode.
If you are still experiencing problems after
testing and troubleshooting the installation,
refer to Contacting Allied Telesyn Technical
Support on page x or visit our web site at
www.alliedtelesyn.com for support
information.
Zobrazit stránku 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 45 46

Komentáře k této Příručce

Žádné komentáře