Allied-telesis x610 Series Layer 3 Uživatelský manuál stáhnout pdf (Strana 84)

Chapter 3: Installing the Hardware

Cabling an

AT-StackXG

Stacking Module

1. Remove the plastic protector from the connector at one end of the

stacking cable.

Figure 46. Removing the Plastic Protector

2. Connect the cable to either Stack Port 1 or Stack Port 2 on the

stacking module and secure by tightening the two captive

thumbscrews.

3. Remove the plastic protector from the connector at the other end of

the stacking cable and connect it to a Stack Port on the stacking

module in the next switch of the stack. A stacking cable must

crossover and connect to a different port on the next stacking module.

Stack Port 1 on a module must connect to Stack Port 2 on the next

module.

Caution

Do not connect two stack Port 1 ports or stack Port 2 ports together.

1244

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 119 120

Žádné komentáře

Allied-telesis x610 Series Layer 3 Uživatelský manuál Strana 84