Allied-telesis AT-S62 Uživatelský manuál Strana 541

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 822
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 540
AT-S62 Management Software Menus Interface User’s Guide
Section IV: Spanning Tree Protocols 541
Displaying MSTP Port Settings and Status
The MSTP Port Parameters menu, shown in Figure 182 on page 536, has
two selections for displaying a variety of MSTP port information. The two
menu selections are described below. (To display the menu, from the
MSTP Menu, type P to select MSTP Port Parameters.)
2 - Display MSTP Port Configuration
This selection displays a menu that contains the current port settings for
the following MSTP parameters:
Edge-Port
Point-to-Point Port
External or Internal Port Cost
Port Priority
3 - Display MSTP Port State
This selection displays a menu that contains the following MSTP operating
status for a port:
State - Identifies the MSTP state of the port. Possible states are:
discarding, learning, and forwarding. A state of disabled means the
port has not established a link with its end node.
MSTI-ID - The MSTI ID of the VLAN containing the port. (The MSTI ID
for a regional boundary port is always 0, even if the VLAN containing
the port has been associated with a MSTI other than CIST.)
Role - Indicates the MSTP role of the port. Possible roles are: root,
alternate, backup, and designated.
Internal Port Cost - The port cost when the port is connected to a
bridge in the same region.
Version - Indicates whether the port is operating in MSTP mode or
STP-compatible mode.
Zobrazit stránku 540
1 2 ... 536 537 538 539 540 541 542 543 544 545 546 ... 821 822

Komentáře k této Příručce

Žádné komentáře