Allied-telesis AT-S60 Uživatelský manuál stáhnout pdf (Strana 173)

AT-S60 Command Line User’s Guide

171

SET MSTP

Syntax

set mstp [default]

[forceversion=forcestpcompatible|normalmstp]

[hellotime=hellotime] [forwarddelay=forwarddelay]

[maxage=maxage] [maxhops=maxhops]

[configname=”name”] [revisionlevel=number]

Parameters

default Disables MSTP and returns all bridge and port MSTP

settings to the default values. This parameter cannot

be used with any other parameter. (This parameter

performs the same function as the RESET MSTP

command.) The spanning tree protocol must be

disabled to use this parameter.

forceversion Controls whether the bridge will operate with

MSTP or in an STP-compatible mode. If you select

MSTP, the bridge will operate all ports in MSTP,

except for those ports that receive STP or RSTP

BPDU packets. If you select Force STP Compatible,

the bridge uses its MSTP parameter settings, but

sends only STP BPDU packets from the ports

The options are:

forcestpcompatible The bridge uses the MSTP

parameter settings, but

transmits only STP BPDU

packets from the ports.

normalmspt The bridge uses MSTP. The

bridge sends out MSTP BPDU

packets from all ports except

for those ports connected to

bridges running STP. This is

the default setting.

hellotime Specifies the time interval between generating and

sending configuration messages by the bridge. This

parameter can be from 1 to 10 seconds. The default is

2 seconds.

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 302 303

Žádné komentáře

Allied-telesis AT-S60 Uživatelský manuál Strana 173