Allied-telesis AT-MCF2012LC/1 Uživatelský manuál stáhnout pdf (Strana 44)

Chapter 2: Installation

Planning the Installation

10/100Base-

TX Twisted

Pair Cabling

Table 7 lists the cable requirements for the 10/100Base-TX

twisted pair ports. For port pinouts, refer to “10/100Base-TX

Port Pinouts” on page 62.

Note

The default setting for a twisted pair port is Auto-

Negotiation and auto-MDI/MDI-X. In the default

setting, a port’s speed, duplex mode, and MDI/MDI-X

setting are set automatically. Disabling Auto-

Negotiation and manually configuring a port requires

the optional management module for the chassis.

Table 7. Twisted Pair Cable and Distances

Speed Cable Type

Maximum

Operating

Distance

10 Mbps Standard TIA/EIA 568-B-

compliant Category 3 or

better shielded or

unshielded cabling with

100 ohm impedance and

a frequency of 16 MHz.

100 m (328 ft)

100 Mbps Standard TIA/EIA 568-A-

compliant Category 5 or

TIA/EIA 568-B-compliant

Enhanced Category 5

(Cat 5e) shielded or

unshielded cabling with

100 ohm impedance and

a frequency of 100 MHz.

100 m (328 ft)

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 63 64

Žádné komentáře

Allied-telesis AT-MCF2012LC/1 Uživatelský manuál Strana 44