Allied-telesis AT-CV5000 Uživatelský manuál stáhnout pdf (Strana 74)

Chapter 3: Working with Line Cards and other Modules

Removing a Converteon™ Line Card

To remove a Converteon™ line card, perform the following procedure:

Caution

Be sure to observe all standard electrostatic discharge (ESD)

precautions, such as wearing an antistatic wrist strap, to avoid

damaging the device. A line card can be damaged by static

electricity.

1. Select the line card in the AT-CV5000 chassis you want to remove.

2. Using a Phillips screwdriver, loosen the captive screws at the top of

the installed line card.

3. Locate the line card removal tool, as shown in Figure 48.

Figure 48. Line Card Removal Tool

4. Hook the slot at the end of the removal tool onto the captive screw at

the top of the line card, and pull towards you to remove the card from

the chassis, as shown in Figure 49.

Figure 49. Removing a Line Card from an AT-CV5000 Chassis

5. Install an AT-CV5PNL1 blank slot cover in the empty slot, as described

in “Installing an AT-CV5PNL1 Blank Slot Cover” on page 90.

1137

1138

-CM202

ML/

SML

FD/

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 113 114

Žádné komentáře

Allied-telesis AT-CV5000 Uživatelský manuál Strana 74